#main-content .dfd-content-wrap {margin: 0px;} #main-content .dfd-content-wrap > article {padding: 0px;}@media only screen and (min-width: 1101px) {#layout.dfd-portfolio-loop > .row.full-width > .blog-section.no-sidebars,#layout.dfd-gallery-loop > .row.full-width > .blog-section.no-sidebars {padding: 0 0px;}#layout.dfd-portfolio-loop > .row.full-width > .blog-section.no-sidebars > #main-content > .dfd-content-wrap:first-child,#layout.dfd-gallery-loop > .row.full-width > .blog-section.no-sidebars > #main-content > .dfd-content-wrap:first-child {border-top: 0px solid transparent; border-bottom: 0px solid transparent;}#layout.dfd-portfolio-loop > .row.full-width #right-sidebar,#layout.dfd-gallery-loop > .row.full-width #right-sidebar {padding-top: 0px;padding-bottom: 0px;}#layout.dfd-portfolio-loop > .row.full-width > .blog-section.no-sidebars .sort-panel,#layout.dfd-gallery-loop > .row.full-width > .blog-section.no-sidebars .sort-panel {margin-left: -0px;margin-right: -0px;}}#layout .dfd-content-wrap.layout-side-image,#layout > .row.full-width .dfd-content-wrap.layout-side-image {margin-left: 0;margin-right: 0;}
Ready to get hard anodized in black, these fully adjustable Small Block water necks are XRP made here in the USA from genuine aircraft forgings in -20 and -16 sizesNext
NEW from are these Mechnical Fuel Injection hose ends made to fit male -3 size injector nozzles with a the standard 45 degree SAE flare nose. (Also available for -3 male 37 degree flare) Crimp-on to 3/16″ ID rubber or -4 stainless braided PTFE hose. These one piece bend hose ends are made from 316 stainless steel with an Aluminum, 2024-T6 pinned on swivel nut and have a .152″ hole through for high fuel flow with less pressure drop. Straights and all standard bends from 30 to 180 degrees
